ENGLISH
2.3 Panel Mounting and Removing
3. Electrical Wiring Diagram
5
Relay Outputs
Power Supply Input
Temparature Sensor Input
( PT-100)
230V
( %15) 50/60Hz ,
115V
( %15) 50/60Hz ,
24V
( %15) 50/60Hz ,
24V
( %15) 50/60Hz ,
Z
V
±
V
±
V
±
W
±
10...30 V
1.5 W
Must be determined in order.
1-Before mounting the device in your panel, make
sure that the cut-out is of the right size.
2-Insert the device through the cut-out. If the
mounting clamps are on the unit, put out them
before inserting the unit to the panel.
3- Insert the mounting clamps to the fixing sockets
that located left and right sides of device and
make the unit completely immobile within the
panel
1-Pull mounting clamps from left and right
fixing sockets.
2-Pull the unit through the front side of the
panel
Before starting to remove the unit
from panel, power off the unit and
the related system.
c
2
1
3
5
4
6
8
7
9
10
P/N :
ESM-3721
L
N
1
1
1
2
a
3
2
1
3
3
2
To reduce the effect of electrical noise on device, Low voltage line (especially sensor input
cable) wiring must be separetely from high current and voltage line.
If possible, use shielded cable and shield must be connected to ground only one side.
c
7
8
9
10
a
2x3
A
@ 250V
V
5A @250V
V
230
V
V
± 15%
50/60Hz - 1.5VA
2
3
4
1
ALARM
ENGINE
5
6
11 12
HEA
T
7
8
9
10
a
2x3
A
@ 250V
V
5A @250V
V
230
V
V
± 15%
50/60Hz - 1.5VA
2
3
4
1
ALARM
ENGINE
5
6
11 12
HEA
T