ENGLISH
When SET button is pressed for 5
seconds, “P” led starts to blink. If
programming mode entering
password is different from 0,
programming mode entering screen
will be observed.
Main Operating Screen
Programming Screen
Change the value with increment
and decrement buttons.
Compressor Output
Hysteresis Parameter Value
Press SET button for accessing to the parameter
value. Press increment button for accessing to
the next parameter, press decrement button for
accessing to the previous parameter
Press set button for saving
the parameter.
Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter
Password Entering Screen
Programming Mode
Entering Screen
Press SET button for
accessing to the
password entering screen.
Password Entering Screen
Enter programming mode accessing
password with increment and decrement
Note-2:
If programming mode accessing password is 0 parameter values can be seen.But
parameter values can not be changed.
Press SET/OK button for
entering the password.
Note1: If programming mode
accessing password is 0,
Temperature Unit Selection
Screen is observed
instead of programming
screen accessing password
Compressor Output
Hysteresis Parameter Value
If no operation is performed in programming mode for 20 seconds, device turns to main
operation screen automatically..
i
Compressor Output
Hysteresis Parameter
6.4 Entering To The Programming Mode, Changing and Saving Parameter
14
7. Failure Messages in ESM-
3712-C
N Cooling Controller
1- message blinking
. S
no sensor connection. While this message shown on this display, if buzzer function selection
parameter is 3 or 4, internal buzzer starts to operate.
.Cabinet temperature sensor failure
ensor connection is wrong or there is
O
F
O
C
P
S
ü
ESM-3712CN
O
F
O
C
S
P
ü
ESM-3712CN
O
F
O
C
S
P
ü
ESM-3712CN
O
F
O
C
S
P
ü
ESM-3712CN
O
F
O
C
S
P
ü
ESM-3712CN
O
F
O
C
S
P
ü
ESM-3712CN
O
F
O
C
S
P
ü
ESM-3712CN
O
F
O
C
S
P
ü
ESM-3712CN