Comment
1
3
4
7. OPERATION
7.1 Front Panel Description
3
4
5
10
9
6
7
8
12
1
2
Multi Function Display. This is used for displaying the electrical measurements
during normal operation and editing / inspecting programming parameters in
programming mode.
Failure Indicators. Detailed information available in Section 9
12
The Display Scroll Button is used for rotating between measurement screen in
normal operation and between programming parameters in programming mode.
Green LED lights to indicate that alternator output is available and within the
Parameters set b y P00 and P01.
Green LED lights to indicate that engine is running, as indicated by the signals
selected by p rogram parameter Engine Started Signals (P18).
6
Engine Start button. Starts the engine. A green LED in the corner shows that the
button has been pressed.
5
Engine Stop button. Stops the engine. A red LED in the corner shows that the
button has b een pressed.
11
Prog/Test. Lights all the LEDs and segments on the panel so that you can see if
any are not working. Holding the button pressed for ten seconds puts the unit
into Programming mode.
9
Up/Reset. Restores unit operation after it has latched in a fault condition. The
Increment (up a rrow) function is used in Programming mode as detailed in
Section 5.3 Changing and Saving Technician Parameter Value
10
Down/Silence Alarm. Silences the audible alarm. The Decrement (down arrow)
button is u sed in Programming mode as detailed in Section 5.3.
7
Power On. Turns on the unit. A green LED in the corner of the button shows that
the unit is on
8
Power Off. Turns off the unit and stops the engine if it is running. In the Off state
the unit c onsumes no current from the battery.
11
Number
2
33