B. Batterycheck.
As the instrument has been stored for some time before transportation it is important to check
the battery-condition.
To do this turn the mainswitch On.
When starting the instrument, the monitor turns on in spectrum-mode and LED nr 2 on the
front-display will be lit. The two digit LED-display indicates "SP" for spectrum.
The loudspeaker is switched off when the instrument is turned on.
Push the No 6 button on the keypad to read the battery condition. The condition is indicated on
the two digit LED-display with a value between LO, 1-9, HI.
If the battery needs recharging, use the power-supply enclosed.
NOTE, The instrument should be turned off when the battery is recharged.
The two digit LED-display (automatically turned on when recharging) shows "CH", for
charging, while recharging.
Recharging from discharged battery to about 85% capacity takes aprox.3 hours.
C. Connection and installing a satellite dish.
When the battery is charged the instrument is ready to use.
Connection of coaxial-cable and LNB is preferably done when the instrument is turned off. In
case of connecting when the instrument is On and if a short-circuit occur, it's no harm done due
to the fact that the instrument is protected against such a failure and will automatically turn off
itself.
After correcting the problem, restart the instrument and it will operate normally.
The instrument starts in the spectrum-mode which makes it easy to detect the satellite/s You're
looking for. If You want to switch on the loudspeaker function (beeper), press the No 8 button
(on/off).
When a satellite is received, the monitor immediately show white "peaks" which are getting
bigger when the signal is increasing, see picture.
