8
The signal-strength of the chosen channel is shown in the LCD (in dBuV).
Press the OK-button and the meter will “zoom in” at the frequency which the
marker is pointing at.
3. Menu
The following menu is shown on the display when pressing down the
MENU
button:
This is the main menu. Use the “UP”/”DOWN” buttons to scroll up and down in the
menu system. Use the “OK” button to enable the selected function.
3.1 Beeper
Choose
Beeper On/Off
in the main menu to turn the beeper (pitch tone) On or
Off. It is only audible in
Single channel mode
. The idea is to help finding the
strongest signal on the selected channel by listening to the highest pitch of the
tone.
3.2 Antenna voltage
Choose
Antenna voltage
in the main menu and select 0V,5V,12V or 24V to
be fed to the ANTENNA port. The power to the antenna port is changed
immediately when the “OK” button is pushed even if you are in the main menu
mode.
CAUTION!
Do not connect the antenna to the antenna port before the correct
voltage is chosen. If the antenna should be fed with 5 Volt and You
accidentally choose 12 Volt instead, it may damage the antenna. The chosen
Voltage output to the antenna port is indicated on the LCD in
Single channel
mode
.
The unit will turn off the antenna-voltage output if a short-circuit occur.
3.3 Setup
1. LCD
- Contrast
Set the contrast of the LCD-display. Lighter or Darker
- Backlite
Set the backlite of the LCD-display On or Off.
2. Beeper volume
Set the volume of the Beeper with a value from 1 (low) to 5 (high).
3. Channel list
Chose the region/channelplan where the meter will be used.
