background image

5.12 Power saving:

 

To save power, eScan2 has a power saving feature, which turns off the display if 
eScan2 has been idle for a while. You can choose between the following options;
5 min, 10 min, 30 min, 1 hour, 2 hours, or never. 

5.13 Lock keyboard: 

Choose whether you want the key lock to turn on after 1 minute or not. The 
default choice is that the key lock is on. 

Connection of external equipment: 

The serial port on the back of the eScan2 uses an RJ11 connector with six 
contact points, which are connected as follows 

 

Synchronization of ETS2 and / or ESD2: 

eScan2 can be used to synchronize the clock to ETS2 or ESD2. After setting the 
clock on eScan2, a positive pulse is sent for 100 ms between pin5 (ground) and 
pin6 (output). If you have connected ETS2 or ESD2, the clock in the connected 
device will be synchronized with eScan2. 

Uploading start list 

It is possible to enter the name, start number and chip number of the participants
under menu option 3 - participants. However, it is also possible to transfer a 
participant list from the registration system, if this supports transfer to Emit ET6. 
In that case, use the utility 'EmitET6', which can be downloaded from 
www.emit.no, for this purpose. However, eScan2 does not support transfer of 
classes and start times - only name, start number and tag number. 

Upgrading eScan2 

eScan2 can be upgraded to the latest firmware version using the eUpgrade 
program, which can be downloaded from www.emit.no. USB drivers for eScan2 
are usually installed automatically, but if you have problems with the 
communication between eScan2 and PC, you can download the latest version of 
the USB driver from https://ftdichip.com/drivers/vcp-drivers/ 

Summary of Contents for eScan2









Reviews: