User Manual
www.emiots.com
Page 7 of 13
SMS CONFIGURATION COMMANDS
Below table contains configuration settings. This settings can be sent via SMS or can be sent via terminal.
1.
We will use below sequence:
set_<COMMAND>@<SERIAL>$<PASSWORD>#<COMMAND STRING>#
2.
For Set Commands – after setting device should response – “success” followed by command.
Ex: “set_server success” OR “set_server failure”
Sr
#
About
Example / Usage
1
SET_SERVER
This command configures the connection settings which consist of service provider
APN, Server IP address/DNS, & Port number.
Usage:
set_server@<serial>%<password>#<apn>,<apnuser>,
<apnpassword>,<serverip1>,<serverport1>,<serverip2>,<serverport2>,<serverip3>,<serv
erport3>#
Example:
set_server@12345%123456#airtelgprs.com,,,13.250.246.255,9022,
13.250.246.255,9022,13.250.246.255,9022#
2
SET_INTERVAL
This command is used to configure the transmission interval. This consisting of IGN On
interval in seconds, IGN Off interval in seconds.
Usage:
set_interval@<serial>%<password>#<on interval>,<off interval>#
Example:
set_interval@12345%123456#10,60#
Valid Values:
10, 20, 30,40,50,60 – for ON Interval in Seconds
10,20,30,40 to 1800 – for OFF Interval in Seconds, Less than 30 minute (1800 Sec)
3
SET_VIN
This command is used to set the vehicle identifier number
Usage:
set_vin@<serial>%<password>#<vehicle number>#
Example:
set_vin@12345%123456#GJ01RH4270#
Note: Max 20 character limit.
4
SET_CLIENT
This command is used to set the client ID
