9 |
ENGLISH
you to wirelessly share an Internet connection with other wireless routers or access
points that support WDS.
7.1 Turn on the WDS function of the wSURF
These are the instructions for use of WDS. In this example two wireless routers will be
used, the wSURF is connected to the Internet. The other wireless router repeats the
wireless signal.
1.
Turn on your computer
2.
Open your Internet browser (for instance Internet Explorer, Netscape or Firefox).
3.
Enter ‘http://192.168.1.1’ in the address bar.
4.
Press Enter or click ‘Go to’.
5.
Enter ‘admin’ in the ‘User Name’ field (Note! This field is case sensitive).
6.
Enter ‘admin’ in the ‘Password’ field (Note! This field is case sensitive).
7.
Click ‘Log In’.
8.
The router will display a welcome screen.
9.
Click ‘Advanced’.
10. Click ‘Wireless’.
11. Click ‘Setting’.
12. Set ‘Mode’ to ‘WDS’.
13. Click ‘Submit’.
14. Click ‘Ok’.
15. Click ‘WDS’ in the upper menu.
16. Check ‘Enable WDS’.
17. Enter the WLAN MAC address (BSSID) of the other router in the ‘Add WDS AP’
field. You may find this MAC address on the bottom of said router.
18. If you cannot find this address, click the ‘Show AP’ button. Note down the BSSID
of the router you wish to link over WDS, and close the ‘Show Ap’ screen.
19. Click ‘Submit’.
20. If you wish to add more routers to your WDS network, repeat steps 17 and 18 for
each router.
21. Click ‘Save’.
22. Click ‘Ok’.
To establish a WDS connection, you will need to enter the MAC address of the
wSURF into the receiving device. For more information you will need to refer to the
manual of the receiving device.
