10 |
ENGLISH
7.2 Things to keep in mind when using WDS
•
All routers in your WDS network need to be in the same IP range (for instance,
192.168.1.1 for router A and 192.168.1.200 for router B). Sometimes you will
need to set a fixed IP address on the receiving device.
•
WEP security needs to be identical on both devices.
•
The channels of the wireless connections need to be identical.
•
The names (SSID) of the wireless connections do not need to be identical.
•
It is not recommended to use MAC Address Control in combination with WDS.
•
DHCP server(s) on the second (or third or fourth) router need(s) to be disabled.
8.0
Frequently asked questions
Q. I receive the message ‘The IP address of the network adapter is incorrect’. What
can I do?
A. This message appears when the computer did not receive a correct IP address
from the router. Make sure all cables are correctly connected. If necessary, reset
the wSURF and try again. It is recommended that you configure the router using
a cabled connection (not wireless). When the cabled connection is working
properly you can setup the wireless connection as explained in this manual.
Q. How do I reset the wSURF?
A.
You can reset the modem by following the procedure below:
1.
Turn on the modem and wait for it to boot.
2.
Press down the reset button next to the on/off button for about twenty
seconds, using a paperclip
3.
The modem has been reset.
Q. My wireless signal is weak or unstable. What could be the cause?
A.
Take the modem to another location and see if the signal strength increases. If
possible place the modem in an open space. The mains box for instance is not a
good place for a wireless modem.
A.
You can change the channel of the modem to see if the signal strength
increases. Follow the instructions below:
1.
Open your Internet browser (for instance Internet Explorer, Netscape or
Firefox).
2.
Enter ‘http://192.168.1.1’ in the address bar.
3.
Press Enter or click ‘Go to’.
If your wireless network is secured, you will also need to configure the security of your
other wireless device. In WDS modus, only WEP security can be used. See chapter
5.2 for WEP security.
Attention! WPA2 can not be used when securing the connection.
