EMG Bomber X, Instruction Manual

Page: 16 / 32

16
HOW TO RECHARGE THE
BATTERY
lithium battery, do not replace with incorrect bat-
tery type, danger of explosion.
WARNING
In a ventilated area, insert the charger connector into the corresponding
battery charging connector, then
the charger into a standard current plug a 230V
~ 50Hz.
Do not recharge the battery in closed and poorly ventilated places!
Verify that the charger connector and plug are not damaged.
During charging, the charger indicator is red; when the battery is full, the
indicator turns green. The time needed for a full charge is approximately
6 hours. This may vary considering the residual charge.
The supplied chargers have 3 operating modes:
Green light
: end of recharging opera-
tion (battery charged) or no battery connected.
Red light
: charging operation in progress
Light off
: charger in standby (energy saving mode activated).
This last mode is activated after about 30 seconds / one mi-
nute after the charging operation is finished or with
the charger activated without any battery connected.
To return to normal operation, disconnect the charger from the mains for
about one minute (reset the standby function) and reconnect it to carry
out a new charging operation.
After charging is completed, pull out the charger plug from the socket,
then disconnect the charger connector from the bicycle charging hole.
Do not leave the charger connected to the socket for a long time after
charging has been completed.
If a smell comes out from the charger during charging, the temperature
may have become too high; please stop charging immediately and send
the unit for maintenance.
Use only the charger supplied with the bicycle to avoid damage to the
battery and not to void the warranty.