1.
Disconnect electrical power to the branch circuit at
the circuit breaker or fuse box before attempting to
wire the ceiling fan.
2.
Position the supply wires to the left side of the
outlet box (Figure 16); position the fan wires to the
right side.
3.
Partially insert the remote control receiver (flat side
up) until one end rests on the hanger ball as shown
in Figure 16. Be sure to insert the antenna wire
first, making certain that it passes completely
through the mounting bracket.
9
U.L. Model No.: CF230
How to Wire Your Ceiling Fan
(Standard)
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WARNING
!
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the ceiling cover and the
ceiling.
WARNING
!
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and
that no bare wire is visible at the wire
connectors, except for the ground wire.
4.
Refer to Figure 16 and 17 and connect the receiver
wires to the supply wires and the fan motor wires
as follows:
a.
Securely connect the green grounding wires from
the hanger ball and the hanger bracket to the
supply grounding conductor (this may be a bare
wire or a wire with green insulation).
b.
Securely connect the supply white (neutral) wire to
the receiver white (AC IN N) wire.
c.
Securely connect the supply black wire (hot) wire to
the receiver black (AC IN L) wire.
d.
Securely connect the fan motor white wire to the
receiver white (TO MOTOR N) wire.
e.
Securely connect the fan motor black wire to the
receiver black (TO MOTOR L) wire.
f.
Securely connect the fan motor blue wire to the
receiver blue (FOR LIGHT) wire.
NOTE: Failure to properly connect the receiver
wires will damage the device and render it non-
operable.