Emerson unidrive m, Installation And Operating Manual, Page: 9 / 88

SI-Safety Installation & Operating Manual
9
Issue number: 1
Saf
ety
in
fo
rm
atio
n
Devi
ce type
Te
chnica
l
safety
features
Inst
all
ation
SI-Safety module
response
times
S
tar
t-up
M
aintenance
Te
chnical dat
a
SI-Safety
error types
En
coder
ty
pes
Va
lidatio
n
report
Enc
oder
ad
aptor
Am
endment
s
Index
1.5 Intended use
The SI-Safety module expansion module is a programmable safety controller used in
the manufacture of safety trip circuits and other safety functions. This module is
designed for the following uses:
•
In EMERGENCY STOP equipment.
• As a safety components as defined in EC Machinery Directive 2006/42/EC.
• As a PES for risk reduction as defined in EN 61508.
• In safety power circuits in accordance with EN 60204-1 and EN 60204-32.
• As a PES for functional safety as defined in EN 62061.
• As an SRP/CS as defined in EN ISO 13849.
• As a device for producing the safety functions defined in EN 61800-5-2.
• As a logic unit for signal conversion and processing in two handed circuits as
defined in EN 574.
1.6 General safety instructions
• To avoid personal injury and damage to equipment, all work on this device must be
carried out by personnel with training regarding the technical aspects of electrical
engineering.
• Each appropriately skilled person must be familiar with the operating instructions
(cf. IEC 60364).
• Each appropriately skilled person must, as a minimum requirement, have an in-
depth knowledge of national health and safety at work (HSW, i.e. accident
prevention) specifications and legislation.
• Use of these devices is restricted to their intended use, in accordance with the
previous itemised list. Due compliance with the figures and data listed in Table
3-1 on page 17 is mandatory.
• The contents of this installation manual is restricted to the basic functions of these
devices, and the installation procedure for them. More detailed information about
the programming and re-configuration of these devices can be found in the 'SI-
Safety module programming manual'. Detailed knowledge and understanding of
these aspects is vitally necessary prior to first time installation and/or modification of
equipment functions or device parameters.
• Commissioning / start-up is only permitted on condition that the EMC directive is
followed to the letter. On the basis of EMC test specifications EN 55011:2007 +
A2:2007 and EN 61000-6-2:2005.
• For storage and transport, due compliance is required with the conditions defined in
EN 60068-2-6 in relation to the figures given in Table 3-1 on page 17.
• Compliance with the wiring and connection instructions in the 'Installation' chapter is
mandatory.
• The applicable safety specifications must be observed in respect of this application.
• The configured monitoring functions and their parameters and links must be verified
through the use of a validation report.
The SI-Safety module expansion module is a safety component as defined in Annex IV
of the EC Machinery Directive 2006/42/EC. It was developed, designed and produced
in strict accordance with the above directive, and with the EC EMC Directive 2004/108/
EC.
Safety instructions
WARNING