Command Variations:
TI Series 305 and 405 PLC’s return 5 words of network status information
when using CALL PLCREAD with cmd = 1. The following example describes
a typical way to read the status information:
Numbers in bold cannot be
changed
10 DIM stat%(5)
20 CALL PLCREAD(1,
1
,
0
,
5
,stat%(1))
This will store
Last Error and Previous Error
in stat%(1),
Number of
Successful Communications
in stat%(2),
Number of Erroneous
Communications
in stat%(3),
Number of Retries For Header
in stat%(4), and
Number of Retries for Data
in stat%(5). (See your PLC manual for more
details)
You must read 5 words of data any time you wish to read the
network status.
You can reset the status registers by using the CALL PLCWRITE command
with cmd = 1. You must write five words. The data can be arbitrary, since
the net result is resetting the status registers, no matter what you write. See
the example:
Numbers in bold cannot be
changed
10 DIM newstat%(5)
20 CALL PLCWRITE(1,
1
,
0
,
5
,newstat%(1))
(See your PLC manual for more details)
You must write 5 words of data
any time you wish to reset the network status.
All other commands behave as described in previous sections.
PLC Interface Commands PLC Specific Information
71
Summary of Contents for T-60
