7. Fold the wires of the wiring harnesses
into the slot in the motor coupling, slide
the hanger pipe down the wires and
seat the hanger pipe in the motor
coupling.
8. Align the clevis pin holes in the hanger
pipe with the holes in the motor
coupling. Install the clevis pin and
secure with the hairpin clip. The clevis
pin must go through the holes in the
motor coupling and the holes in the
hanger pipe (Figure 6). Push the
straight leg of the hairpin clip through
the hole near the end of the clevis pin
until the curved portion of the hairpin
clip snaps around the clevis pin. The
hairpin clip must be properly installed to
prevent the clevis pin from working
loose.
9. Install the setscrew (supplied in loose
parts bag supplied with ceiling fan) in
the motor coupling and tighten using
the 5/32" setscrew wrench (supplied
with ceiling fan) (Figure 6). A loose
setscrew could cause the fan to
wobble.
10. Screw the two threaded studs (select
the proper length stud as described in
the Ceiling Fan Owner’s Manual) into
the threaded holes in top of the motor.
(Figure 7). (Early motors have two
threaded brackets.) Coil the wires and
4
4. Push the wiring harness connector
(supplied with the SW375 receiver) and
the connectors on the blue wire
(supplied with the control) and yellow
wire (supplied with fans containing
built-in Uplights) through the hanger
pipe until they extend about 4" out of
the pipe (Figure 4).
5. Cut the harness wires approximately 3"
from the end of the pipe. Strip
insulation 1/2" from end of wires.
6. Using wiring connectors supplied,
connect the white, red, yellow, blue, and
brown wires of the wiring harness to the
white, red, yellow (orange wire for early
CF2400 Models), blue, and brown wires
of the ceiling fan (Figure 5). Wires must
be connected color-to-color.
It is critical that the clevis pin in the
motor coupling is properly installed and
the setscrew securely tightened. Failure
to verify that the pin is properly installed
could result in the fan falling.
WARNING
!
MOTOR
COUPLING
HANGER PIPE
HAIRPIN
CLIP
CLEVIS
PIN
SETSCREW
Figure 6
4"
DOWNROD
CUT HERE
3"
YELLOW LEAD (Built-in Up Light Only)
(See NOTE 3)
WIRING
HARNESS
BLUE WIRE
Figure 4
BLUE WIRE TO
BLUE WIRE
Off
On
Up
Down
Lights
Fan
Sleep
FAN BLADES REMOVED
FOR CLARITY
HANGER
PIPE
WHITE WIRE
BLACK WIRE
WIRING HARNESS
CONNECTOR
YELLOW WIRE
TO YELLOW
WIRE (Built-in
Up Light Only)
BLUE WIRE TO
BLUE WIRE
SW375 RECEIVER
TO
120V SUPPLY
BROWN WIRE
TO BROWN
WIRE
YELLOW WIRE
TO YELLOW WIRE*
(Built-in Up Light Only)
SW350
WALL CONTROL
OR
ON/OFF WALL
SWITCH
RECEIVER
CONNECTOR
BLACK WIRE
(NOT USED)
RED WIRE TO
RED WIRE
WHITE WIRE TO
WHITE WIRE
LIGHT
FIXTURE
FAN
HOUSING
* ON SOME CF2400 MODELS,
THE WIRE FROM MOTOR
MAY BE ORANGE
Figure 5
BP7253-2 4/28/06 11:58 AM Page 4
