1 0
OPERATING INSTRUCTIONS
• Make sure you have installed the batteries in the battery compartment, or
• Connect the AC power cord plug to a 120V 60Hz AC outlet.
GENERAL CONTROLS
BASS BOOST ON
/OFF
Button
Set this button to the “
ON
” position to increase the bass response. Set to the
“
OFF
” position for normal bass response.
FM MODE Selector
Normally you should leave this switch set to the “
ST.
” position for FM Stereo
reception. However if you are listening to a distant FM Stereo station and the
reception is noisy or weak set this switch to the “
MONO
” position. This will
normally provide some improvement in reception, however the sound will no longer
be in stereo.
LISTENING TO THE RADIO
1.) Slide the
POWER OFF/CD/RADIO
selector switch, located on the top cabinet,
to the
RADIO
position. The
POWER
indicator will light.
2.) Select the desired band –
AM
or
FM
– by sliding the
BAND
selector, located
on the right side, to the correct position.
3.) Fully extend the telescoping FM rod antenna.
4.) Set the
FM MODE
button to the Stereo “
ST.
” position.
5.) Tune to the desired station by slowly rotating the
TUNING
control on the right
side. If you tune to an FM Stereo station the
FM ST.
indicator will light.
6.) Rotate the
VOLUME
control to adjust the volume to the desired level.
7.) Set the
BASS BOOST
switch to the “
ON
” position to increase the bass
response if desired.
8.) When you are finished listening slide the
POWER OFF/CD/RADIO
selector
switch back to the
POWER OFF
position. The
POWER
indicator goes off.
SB250A_011205.p65
12/1/2005, 17:25
10
