#
Item
1
network status LeD
2
Module status LeD
3
Link/Activity LeD (port 1)
4
Link/Activity LeD (port 2)
Test sequences are performed on the Network and Module Status LEDs during startup.
Figure 7: Front View - SDUPNETCARD Details
LED State
Description
Comments
Network Status LED
off
offline
no power
no connection with Io Controller
Green
online (RUn)
Connection with Io Controller established
Io Controller in RUn state
Green, 1 flash
online (stoP)
Connection with Io Controller established
Io Controller in stoP state or Io data bad
IRt synchronization not finished
Green, blinking
Blink
Used by engineering tools to identify the node on the network
Red
Fatal event
Major internal error (this indication is combined with a red module
status LeD)
Red, 1 flash
station name error
station name not set
Red, 2 flashes
IP address error
IP address not set
Red, 3 flashes
Configuration error
expected Identification differs from Real Identification
Module Status LED
off
not Initialized
no power oR Module in setUP or nW_InIt state.
Green
normal operation
Module has shifted from the nW_InIt state.
Green, 1 flash
Diagnostic event(s)
Diagnostic event(s) present
Red
exception error
Device in state eXCePtIon.
Fatal event
Major internal error (this indication is combined with a red net- work
status LeD)
Alternating Red/Green
Firmware update
Do not power off the module. turning the module off during this phase
could cause permanent damage.
LINK/Activity LED
off
no Link
no link, no communication present
Green
Link
ethernet link established, no communication present
Green, flickering
Activity
ethernet link established, communication present
Table 5. LED Status for SDUPNETCARD
Pin #
Signal
1, 2, 4, 5
Connected to chassis ground
over serial RC circuit
3
RD-
6
RD+
7
tD-
8
tD+
Housing
Cable shield
The Ethernet interface operates at 100 Mbit, full duplex, as required by PROFINET
Table 6.
Ethernet Interface (RJ45 Connectors) for
SDUPNETCARD
8
| 3.0 system Features and General Description