Emerson Rosemount ET310C, Quick Start Manual, Page: 11 / 28

CAUTION
This can cause injury as well as damage to the sensor.
Only remove the protective cap when necessary and then take great
care. Ensure tools and fastenings are kept away from the sensor
when the cap is removed.
3. If the rubber shoe needs to be refitted, ensure the ring is still in place,
then fit the shoe onto the sensor by pushing the two pegs protruding
from the foot of the sensor into the holes in the shoe.
If the ring is missing, do not use the sensor.
4. Carefully place the sensor in the required location on the pipe.
NOTICE
The magnets used in the sensors have a high pull force. To avoid
damage, and to get the precise location for each sensor, initially
place the sensor at an angle to the pipe and then gently lower the
shoe onto the pipe.
Tip
One person should hold the sensor until the strap is installed.
5. Slide the strap through the sensor, pass the strap through the buckle
as in Figure 3-2 . Where possible, position the buckle opposite the
middle sensor to ensure both sides of the strap are tightened evenly.
September 2022 Quick Start Guide
Quick Start Guide 11