Reference Manual
00809-0100-4302, Rev BA
January 2008
Rosemount 1153 Series B
2-12
Electrical
1.
Remove the cover from the terminal side of the transmitter
(see Figure 2-5 on page 2-9).
2.
Connect the power leads to the “SIGNAL” terminals on the transmitter
terminal block (see Figure 2-7 on page 2-12). Torque the terminal
screws to 5 in-lb (0.6 N-m), or hand-tight.
3.
Recheck connections for proper polarity.
4.
Check the cover O-ring grooves for cleanliness. If chips or dirt are
present, clean the seat and mating portion of the cover with alcohol.
Lubricate replacement O-ring with O-ring grease (RMT P/N
01153-0248-0001 or P/N 01153-0053-0001). The transmitter was
qualified using Dow Corning
®
55 Silicone O-ring Grease.
5.
Spray the inside threads of the electronics covers with cover lubricant
(Rosemount P/N 01153-0333-0001 or equivalent) if necessary; if
covers are already sufficiently lubricated, do not spray.
6.
Carefully replace cover and tighten to 16.5 ft-lb (22.4 N-m).
Figure 2-7. Transmitter Terminal
Block.
Do not connect signal leads to the “TEST” terminals.
Test Terminals
Signal Terminals
Summary of Contents for Rosemount 1153 Series B
