Emerson RIDGID RT14000, Owner'S Manual

Page: 14 / 60

14
Blowing Feature
Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Hose Release Button of the
Professional Locking Hose End with the
Ridges on the Blower Port. Push the Hose
End straight into the Blower Port until the
Hose Release Button fully engages the
Blower Port Ridges.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose. See Locking
Accessories section of this manual for
instructions on connecting the Locking
Accessories.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
OPERATION
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
WARNING: To reduce the risk
of injury to bystanders, keep them
clear of blowing debris.
!
!
!
Moving the Wet/Dry Vac
Should it become necessary to pick
the Vac up to move it, the Handles
on each side of the Dust Drum or the
Powerhead Carry Handle should be used
to lift.
To maneuver the Vac, the Cart Push
Handle in the rear of the Vac should be
used.
DRAIN
DRA IN
Cart Push
Handle
Carry
Handle
Dust Drum
Handles (2)