8
U.L. Model No.: CF5100
3. Ceiling Fan Assembly
(continued)
MOTOR
COUPLER
COVER
#8-32 KNURLED
KNOB (2)
#8 EXTERNAL
TOOTH
LOCKWASHER (2)
#8-32 x 1-1/4"
THREADED
STUD (2)
DOWNROD
Figure 11
3.11
NOTE: Make sure the red and brown leads are
capped with wire connectors. During installation of
coupler cover, be sure the red and brown wire
connectors are completely inside motor coupler
cover and not pinched between the motor coupler
cover and motor.
Slide the motor coupler cover over the downrod and
rotate the cover until the threaded studs protrude
(Figure 11).
Install the two #8 external tooth lockwashers and #8-32
knurled knobs (supplied) to secure the motor coupler
cover (Figure 11).
#8-32 x 1-1/4"
THREADED
STUD (2)
MOTOR
7/8"
Figure 10
3.10
Screw two #8-32 x 1-1/4” threaded studs (provided) into
the motor (Figure 10). Leave approximately 7/8” of the
stud extending above the motor.
HANGER BALL
DOWNROD
PIN
SETSCREW
CEILING
COVER
3.12
Pass the 80-inch long motor leads through the opening
in the ceiling cover. Be sure the cover is oriented as
shown (Figure 12).
3.13
Reinstall the hanger ball (Figure 12) on the downrod as
follows. Route the motor leads through the downrod.
Position the pin through the two holes in the downrod
and align the ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan wobble.
3.14
The fan comes with blue, black and white leads that are
80-inches long. Before installing the fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and strip
back insulation 1/2-inch from end of leads.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
Figure 12
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 8
