Emerson Network Router, User Manual

Page: 79 / 96

Installation and Use Manual 73
In
de
x
Discre
te Batc
h
Appendix B
Configuring the Discrete Batch Application
B.1 About this appendix
This appendix explains how to configure the discrete batch application, and provides basic
information on batch operation.
Note: For more detailed information on operating the discrete batch application, see the
Series 3000 MVD transmitter manual.
Note: The discrete batch application is an optional feature, and may not be installed on your
transmitter. To verify that it is installed, choose
View > Installed Options .
Note: For full ProLink II functionality for the discrete batch application, you must connect to the
transmitter using a Modbus connection. If you are using a HART connection, only limited
functionality is available.
B.2 About discrete batching
Discrete batching is used to start flow, then stop flow automatically when the target amount of process
fluid has flowed through the sensor. During a batch, flow may be stopped and resumed. A batch may
also be ended before the target is reached.
B.3 Discrete batch configuration
To configure batching:
1. Choose
ProLink > Configuration
2. Click the
Discrete Batch
tab (see Figure B-1).
a. Configure flow source (see Section B.3.1) and click
Apply
.
b. Configure control options (see Section B.3.2) and click
Apply
.
c. Configure one or more presets, if desired (see Section B.3.3) and click
Apply
.
CAUTION
Changing configuration can affect transmitter operation, including batching.
Changes made to discrete batch configuration while a batch is running do not take
effect until the batch is ended. Changes made to other configuration parameters
may affect batching. To ensure correct batching, do not make any configuration
changes while a batch is in progress.