Hardware Preparation and Installation
MVME6100 Single Board Computer Installation and Use (6806800D58E)
19
Jumpers/switches are used to control those options that are not software configurable. These
jumper settings are described further on in this section. If you are resetting the board jumpers
from their default settings, it is important to verify that all settings are reset properly.
Figure 1-1
illustrates the placement of the jumpers, headers, connectors, switches, and various
other components on the MVME6100. There are several manually configurable headers on the
MVME6100 and their settings are shown in
Table 1-2
. Each header’s default setting is enclosed
in brackets. For pin assignments on the MVME6100, refer to
Chapter 5,
Pin Assignments
.
Items in brackets are factory default settings.
Table 1-2 Jumper and Switch Settings
Jumper/S
witch
Function
Settings
J7
SCON Header
[No jumper installed]
1-2
2-3
Auto-SCON
Always SCON
No SCON
J10,
J15—J18,
J25—J28
PMC/IPMC Selection Headers
[Jumper installed]
1-2
[2-3]
PMC I/O
IPMC I/O for IPMC7xx
support (default)
J30
Front/Rear Ethernet and
Transition Module Options
Header
Refer to
Front/Rear Ethernet and Transition Module
Options Header (J30)
on page 23
for details.
S3
SROM Configuration Switch,
sets board Geographical
Address
Refer to
SROM Configuration Switch (S3)
on page 24
for
details.
S4
Flash Boot Bank Select
Configuration Switch, sets
Write Protect A, Write Protect
B, Boot Bank Select, and Safe
Start
Refer to
Flash Boot Bank Select Configuration Switch (S4)
on page 26
for details.
Summary of Contents for MVME6100 Series
Page 10: ...MVME6100 Single Board Computer Installation and Use 6806800D58E 10 List of Figures ...
Page 58: ...MOTLoad Firmware MVME6100 Single Board Computer Installation and Use 6806800D58E 58 ...
Page 114: ...Thermal Validation MVME6100 Single Board Computer Installation and Use 6806800D58E 114 ...
Page 117: ......
