Emerson Micro Motion 2500, Configuration And Use Manual

Page: 150 / 238

11.2 Use Smart Meter Verification (SMV)
You can run an SMV test, view and interpret the results, and set up automatic execution.
11.2.1 SMV requirements
To use SMV, the transmitter must be paired with an enhanced core processor.
See Table 11‐1 for the minimum version of the transmitter, enhanced core processor, and
communication tool needed to support SMV.
Minimum SMV version Table 11-1:
Item Minimum version (legacy)
Minimum basic SMV trans-
mitter
Transmitter 6.0 8.0
Enhanced core processor 3.6 4.4
ProLink III 1.0 4.0
Field Communicator HART device description: de-
vice rev 6, DD rev 2 HART device description: de-
vice rev 8, DD rev 1
If your devices or tools do not meet the minimum version requirements for SMV, you still
may have access to an older version of meter verification if the option was ordered for your
transmitter. See
Table 11‐2 for a description of the major differences between the older
meter verification and the newer SMV.
Major differences between meter verification and SMV Table 11-2:
Feature Meter verification (older) SMV (newer)
Measurement inter-
ruption Suspended during the test (3 mi-
nutes) No interruption necessary
Result storage No results stored in the transmitter Last 20 results stored in the trans-
mitter (licensed SMV)
Results reporting Pass/fail/abort Pass/fail/abort comparison tables
and graphs for stored test results
(1)
Test start methods Manual only Manual, scheduled, event-based,
Discrete Input
(1) Detailed test analyses such as comparison graphs are not available on the local display.
11.2.2 SMV test preparation
Although it is not necessary to match factory conditions or change the transmitter's
configuration during an SMV test, the test will run more smoothly when conditions are
stable.
Measurement support
142 Micro Motion Model 2500 Transmitters with Configurable Input/Outputs