Emerson MCi210, User Manual

Page: 45 / 78

MCi210 User Guide
45
Issue Number: 2
Safety
in
form
ation
In
tro
duct
ion
M
echan
ical
in
st
all
ation
El
ec
tri
ca
l
in
stallation
Pa
ra
m
ete
rs
V
ariabl
e allo
ca
tion
menus
D
igi
ta
l I/O
Ti
m
e
r
Use
r
pr
og
ra
mmi
ng
Dia
gno
stics
Inde
x
This parameter defines the rate at which Easy Mode cyclic data will be transmitted in milliseconds.
A value of zero disables the transmission of data.
This parameter is reserved to select the profile of predefined output mappings for the transmit link.
If this parameter is set to a non-zero value then Tx Link Source Parameter ( S.10.012 , S.10.022 or
S.10.032 ) and Tx Link Parameter Count ( S.10.013 , S.10.023 or S.10.033 ) will become read-only
with value of 0.
This parameter is used to set the link number for the transmit link. This number should be unique
for each transmit link.
S.10.004 Message Rate
Minimum 0 Maximum 100
Default 0 Units ms
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
S.10.010 Tx1 Link Profile
S.10.020 Tx2 Link Profile
S.10.030 Tx3 Link Profile
Minimum 0 Maximum 0
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
S.10.011 Tx1 Link Number
S.10.021 Tx2 Link Number
S.10.031 Tx3 Link Number
Minimum 0 Maximum 255
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU