Emerson Liebert GXT4-10000RT208, User Manual

Page: 27 / 80

Installation
19 Liebert
®
GXT4
™
User Manual
4. Adjust the direction of the operation and display panel and logo on the Liebert GXT4.
a. Remove the front plastic bezel cover as shown in Figure 2-2 .
Figure 2-2 Remove the front plastic bezel cover
b. Pull the operation and display panel gently, rotate it 90 degrees clockwise and snap it back into
position, as shown in Figure 2-3 .
Figure 2-3 Rotate the operation and display panel
c. Pull the logo on the front plastic bezel cover gently, rotate it 90 degrees clockwise and snap it back
into position. The rotated front plastic bezel cover is shown in Figure 2-3 .
d. Replace the front plastic bezel cover on the Liebert GXT4. At this point, the UPS operation and
display panel and logo have been rotated 90 degrees clockwise, which provides upright viewing
for users.
5. Place the Liebert GXT4 and any battery cabinets on the support bases. Each Liebert GXT4 needs two
support assemblies.
2.4.2 Rack Installation
The Liebert GXT4 UPS and external battery cabinets (EBC), when installed in a rack enclosure, must be
supported by a shelf or rack-mount rails. The Liebert GXT4 UPS and EBC units ship with all required
hardware to allow rack-mount installation. Because different rack-mount options install differently, refer to
the installation instructions provided with the rack mount kit being used.
!
CAUTION
The GXT4 is heavy; see 8.0 - Specifications . The UPS must be installed as near the bottom of a
rack as possible. If placed too high, it can make the rack top-heavy and prone to tipping over.
Front plastic
bezel cover
Operation and
display panel
rotated clockwise
90 degrees