Installation
12
3.8
Side Panels—Remove and Replace
Knurr DCM side panels are simple to remove and replace, making it easier to install equipment.
Panel removal also eases maintenance and replacing equipment.
3.8.1
Remove a Panel
Side panels are attached to the Knurr DCM with 10 quarter-turn plastic retainers. The top of the side
panel has a lip that hangs on the top of the cabinet.
To remove a panel, use a large, flat-blade screwdriver to turn each plastic retainers one-fourth of a
turn or 90 degrees counterclockwise. Lift the panel up and away from the rack. Set it aside.
3.8.2
Replace a Side Panel
1.
Hang the side panel on the lip at the top of the Knurr DCM frame.
2.
Use a large, flat-blade screwdriver to turn each of the 10 panel retainers clockwise one-fourth of a
turn or 90 degrees.
Table 4
Optional side/partition panel sizes and part numbers
Height, mm
Depth, mm
Part Numbers
Side Panels
Partition Panels
1200
1000
1100
1200
2000
1000
1100
1200
2100
1000
1100
1200
NOTE
Spinning the plastic quarter-turn retainers more than 90 degrees could damage the retainers.
