May 2022
Installation, Operation and Maintenance Manual
VCIOM-01496-EN Rev. 0
6
Assembling Procedure
Section 2: Assembling Procedure
•
Now the Local Interface is connected to the actuator, see Figure 8.
•
Take the 4 screws removed from terminal board cover and use them to fix the Local
Interface to the actuator, using the 5 mm Allen key, see Figure 9.
Figure 8
OM3 kit connected to the EPI2 terminal board
Figure 9
Fixing the local interface onto the EPI2 actuator
NOTE:
Please note that the design of the Local Interface black connector has been engineered to
allow the installation in one way only. Due to the special design, it is not possible to reverse
the connection of the 4 cables to the terminal board and it is not possible to make a wrong
connection of the connector.
•
The installation of the OM3 Local Interface module onto the EPI2 actuator is
now complete.
screws
