i2P-100 Transducer
Instruction Manual
Form 5777
September 2004
4
W8723
CONDUIT
CONNECTION
FIELD
TERMINATION AND
ELECTRONICS
MODULE CAP
CONVERTER
MODULE CAP
Figure 3. Type i2P-100 Electro-Pneumatic Transducer
Mounted on a Size 30 667 Sliding-Stem Actuator
Educational Services
For information on available courses for the Type
i2P-100 Electro-Pneumatic Transducer, as well as a
variety of other products, contact:
Emerson Process Management
Educational Services, Registration
P.O. Box 190; 301 S. 1st Ave.
Marshalltown, IA 50158 - 2823
Phone: 800 - 338 - 8158 or
Phone: 641 - 754 - 3771
FAX: 641 - 754 - 3431
e-mail: [email protected]
Note
Fisher does not assume responsibility
for the selection, use and maintenance
of any product. Responsibility for the
selection, use and maintenance of any
Fisher product remains with the
purchaser and end-user.
W8693
CONDUIT
CONNECTION
FIELD
TERMINATION AND
ELECTRONICS
MODULE CAP
CONVERTER
MODULE CAP
Figure 4. Type i2P-100 Electro-Pneumatic Transducer
Mounted on a Size 33 1052 Rotary Actuator, 3610J Positioner
and V300B Rotary Valve.
Installation
The i2P-100 transducer has been designed and
approved for use with either air or natural gas as the
supply medium. In normal operation the unit will vent
the supply medium into the surrounding atmosphere
unless it is remotely vented. When using natural gas
as the supply medium in a non-hazardous location,
remote venting of the unit is required. Failure to do
so could result in personal injury, property damage,
and area re-classification. For hazardous locations
remote venting of the unit may be required,
depending upon the area classification, and as
specified by the requirements of local, regional, and
federal codes, rules and regulations. Failure to do so
when necessary could result in personal injury,
property damage, and area re-classification.
WARNING
To avoid personal injury or property
damage from the sudden release of
pressure:
D
Always wear protective clothing
and eyewear when performing any
installation operations.
D
If installing into an existing
application, also refer to the WARNING
at the beginning of the Maintenance
section of this instruction manual.
D
Check with your process or safety
engineer for any additional measures
that must be taken to protect against
process media.