Types 95L, 95H, 95HP, and 95HT
D100256X012
Instruction Manual
Form 1151
November 2009
www.fisherregulators.com
Types 95L, 95H, 95HP, and 95HT Pressure
Reducing Regulators
W1888
W1888
W5652
Figure 1. Type 95L NPT Body (Left), Type 95H NPT Body (Middle),
and Type 95H Flanged Body (Right) Pressure Reducing Regulators
!
Warning
Failure to follow these instructions or
to properly install and maintain this
equipment could result in an explosion,
fire and/or chemical contamination
causing property damage and personal
injury or death.
Fisher
®
regulators must be installed,
operated, and maintained in accordance
with federal, state, and local codes,
rules and regulations, and Emerson
Process Management Regulator
Technologies, Inc. instructions.
If the regulator vents gas or a leak
develops in the system, service to
the unit may be required. Failure
to correct trouble could result in a
hazardous condition.
Call a gas service person to service the
unit. Only a qualified person must install
or service the regulator.
Introduction
Types 95L, 95H, 95HP, and 95HT direct-operated
pressure regulators are suitable for pressure control of
steam, air, gas, water, oil, and similar fluids requiring
constant outlet pressures between 2 and 400 psig
(0,14 and 27,6 bar). Typical 95L and 95H regulators
are shown in Figure 1.
Description
Type 95L
—Pressure reducing regulator suitable for
controlling many gases and liquids. Cast Iron, Steel, or
Stainless steel bodies are available. Outlet pressure
range is from 2 to 30 psig (0,14 and 2,1 bar) with three
different springs available. Body sizes are available
