Instruction Manual
D103793X012
585CLS Actuator
October 2013
10
WARNING
Use only genuine Fisher replacement parts. Components that are not supplied by Emerson Process Management should
not, under any circumstances, be used in any Fisher valve, because they may void your warranty, might adversely affect the
performance of the valve, and could cause personal injury and property damage.
Parts List
Note
Part numbers are shown for recommended spares only. For part
numbers not shown, contact your Emerson Process Management sales
office.
In the listing below, some parts are related to a 6-inch wide channel yoke leg or an 8-inch wide channel yoke leg. This
refers to the size of the vertical channel iron member of the yoke. This is not to be confused with a 5H or 7-inch
diameter yoke boss, which refers to the actuator-to-valve mounting design.
Some parts are also related to the piston rod or piston rod extension diameter. This measurement should be taken
above the stem connector where the rod is full diameter.
Key
Description
1
Yoke
2
Cable Protector, galvanized steel
3
Travel Indicator, SST
4
Feedback Arm, pl steel
4
Anti-Rotator, steel
5
Machine Screw, steel pl
6
Washer, steel pl
7
Travel Scale, aluminum
8
Handwheel Extension
9
Sleeve Assembly
10
Locking Pin, 416 SST
11
Air Cylinder
Refer to the nameplate attached to the cylinder. Order all
replacement parts for the cylinder from the cylinder
manufacturer. Also, if the handwheel is specified,
order its replacement parts from the cylinder manufacturer.
When corresponding with the cylinder manufacturer,
include the cylinder serial number, model number, and all
other pertinent nameplate information.
12
Pipe Plug, steel
13
Cap Screw, plated steel
14
Cap Screw, plated steel
15
Bushing
16
Nameplate, SST
17
Drive Screw, SST
18
Gear Case, cast iron
19
Worm Gear, bronze
20
Bearing
21
Bearing Retainer, steel
22
Stem Connector, 410 SST
23
Hex Nut, plated steel
Key
Description
24
Handwheel Indicator, SST
25
Chain, SST
26
Drive Screw, plated steel
27
Set Screw, steel
28
Key, steel
29
Front Worm Retainer, steel
30
Back Worm Retainer, steel
31
Worm Shaft, steel
32
Handwheel, cast iron
33
Handgrip, steel
34
Handgrip bolt, steel
35
Handwheel Cap, cast iron
36
Set Screw, steel
37
Zerk Fitting
38
Ball, alloy steel
39
Spring, phosphor bronze
40
Ball Bearing
41
Hex Nut, plated steel
42
Pointer, SST
43
Conduit Clamp
44
Cap Screw, plated steel
45
Machine Screw, plated steel
46
Machine Screw, plated steel
47
Tubing, copper (specify length)
49
Connector, brass
50
Elbow, brass
51
Positioner
52
Machine Screw, SST
53
Lock Washer, SST
54
Needle Valve
55
Pipe Nipple, steel
56
Pipe Tee, steel
