Emerson Dixell XEC Supercap, Installing And Operating Instructions

Page: 4 / 16

1592010460 XEC GB rel.1.0 26.01.2015 XEC 4/16
Warning:

XEC Supercap has to be installed, operated and serviced only by
qualified personnel

do not disassemble, repair or modify this device

before removing XEC Supercap from the electrical panel, switch off
the electrical panel to discharge the capacitors (device connected
to XEC Supercap must remain connected to force closing
procedure of the valve). After switching off, wait at least 1 minute
before removing XEC Supercap.
No responsibility is assumed by Dixell S.r.l. in case of non-compliance with
the above recommendation.
1.1 General rules
XEC Supercap is designed to be used with Dixell products (XEV, IEV
and others); compatibility with Dixell devices has to be verified in the
user manual/technical sheet of the device connected to the XEC. In
case of dubt, please contact Dixell Service department.
Before connecting the device, verify that the power supply is compliant
with the rating.
Separate the power of the device from the rest of the electrical
devices connected inside the electrical panel; XEC Supercap
requires a dedicated transformer.
The secondary of the transformer must never be connected to the
ground.
The failure of the observance of this rule may result in damage to
the XEC Supercap and / or the connected device.
Dixell Srl reserves the right to modify this manual without prior notice.
The documentation can be downloaded from www.dixell.com even prior
to purchase.
Dixell Srl reserves the right to change the composition of its products,
even without notice, ensuring the same and unchanged functionality.