11
FR3 Mounting Instructions
Step 1:
Lift the drive out from the carton and remove the
packaging. The magnetic cores and cable ties are
only included in EMI version drive.
Step 2:
Screw mounting:
Attach the drive to the mounting
plate with four M5X20 (or 3/16 in.) screws and four M5
(or 3/16 in.) nuts. The opening dimension on the
mounting plate should follow required dimension (refer
to the dimension drawing in Table 1 of this document)
DIN Rail mounting:
Lift the drive at an angle about
30 degrees. Align the top hooks of drive DIN rail
mounting slot with DIN rail top edge. Push down and
rotate the drive to clip the bottom hooks on the bottom
DIN rail edge
Step 3: (EMI Version Only)
Input wiring:
•
1P FR3 EMI version: Run the input wires (two line
wires+one grounding wire) through the input magnetic
core before connecting to the input terminal block
(L2/L3) and grounding hole. Tie the input magnetic core
to the input wires with a cable tie.
•
3P 230/480 V FR3 EMI version: Run the input wires
(three line wires + one grounding wire) through the
input magnetic core before connecting to the input
terminal block (L1/L2/L3) and grounding hole. Tie the
input magnetic core to the input wires with a cable tie.
•
3P 575 V FR3 EMI version: Run the input wires (three
line wires) through the input magnetic core before
connecting to input terminal block (L1/L2/L3). The input
grounding wire should not run through the input
magnetic core. Tie the input magnetic core to the input
wires with a cable tie.
Output wiring:
•
1P FR3 EMI Version: Does not have an output
magnetic core. Connect three motor wires to the output
terminal block directly.
•
3P 230/480/575 V FR3 EMI Version: Run three
motor wires through the output magnetic core before
connecting to output terminal block. The output
grounding wire should not run through the output
magnetic core. Tie the output magnetic core to the
output wires with a cable tie.
The maximum distance between the input/output
magnetic core’s top surface is 100 mm (3.94 in.). All
EVM non-EMI version drives do not have
input/output magnetic cores.
