9
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF995
3. Ceiling Fan Assembly
(continued)
DOWNROD
PIN
HANGER BALL
SETSCREW
Figure 12
3.15
Reinstall the hanger ball (Figure 12) on the downrod as
follows. Route the motor leads through the downrod.
Position the pin through the two holes in the downrod
and align the ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan wobble.
3.16
The fan comes with black and white lead wires that are
80-inches long. Before installing the fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly and cut off excess lead wire
and strip back insulation 1/2-inch from end of each lead
wire.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
UPPER GLASS
Figure 13
3.17
Carefully place the upper glass shade onto the ceiling
fan assembly (larger opening up) (Figure 13).
