5.
Remove and retain the three switch housing
mounting screws (Figure 4) from the switch housing
plate. Engage the connector of the switch housing
assembly with the motor connector (Figure 4). The
two connectors are keyed and color-coded and must
be mated correctly (color-to-color) before they can be
engaged. Make sure the connector latch closes
properly.
6.
Position the switch housing assembly on the switch
housing plate and align the holes in the switch
housing assembly with the holes in the plate. Secure
the switch housing assembly by installing the three
M4 x 12mm flat head screws (supplied) (Figure 5).
7.
Carefully turn partially assembled fan upside down
and place in styrofoam from carton, in preparation for
final installation.
8.
Remove the hanger ball by loosening the setscrew in
the hanger ball until the ball falls freely down the
downrod (Figure 6). Remove the pin from the
downrod, then remove the hanger ball. Retain the pin
and hanger ball for reinstallation in Step 9.
9.
Separate, untwist and unkink the three 80” motor
leads. Route the motor lead wires through the
downrod. Remove the upper setscrew from the motor
coupling. Align the clevis pin holes in the downrod
with the holes in the motor coupling. Install the clevis
pin and secure with the hairpin clip (Figure 7). The
clevis pin must go through the holes in the motor
coupling and the holes in the downrod. Be sure to
push the straight leg of the hairpin clip through the
hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent
the clevis pin from working loose. Pull on the
downrod to make sure the clevis pin is properly
installed. Reinstall the upper setscrew in the motor
coupling. Check that the lower setscrew is tightened
securely (Figure 7).
3. Ceiling Fan Assembly
(continued)
M4 x 12mm FLAT HEAD
SCREW (3)
SWITCH HOUSING
ASSEMBLY
Figure 5
SWITCH HOUSING
MOUNTING SCREW (3)
SWITCH HOUSING
ASSEMBLY
MOTOR CONNECTOR
SWITCH HOUSING
CONNECTOR
Figure 4
To avoid possible fire or shock, do not pinch wires
between the switch cup assembly and the switch cup
plate.
WARNING
!
6
U.L. Model No.: CF452
DOWNROD
PIN
SETSCREW
HANGER BALL
Figure 6
