11. Troubleshooting
FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
TROUBLESHOOTING YOUR FAN.
WARNING
!
Make sure main power is turned OFF.
WARNING
!
Make sure main power is turned OFF.
WARNING
!
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules. In order to
maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved
equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes
and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this
equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
TROUBLE
PROBABLE CAUSE
SUGGESTED REMEDY
1. Fan will not start. 1. Loose electrical connections in the
1. Check the electrical connections at the ceiling cover.
ceiling cover.
2. Fan sounds noisy. 1. Blades not attached to fan.
1. Attach blades to fan before operating.
2. Screws holding blades to motor are
2. Tighten screws securely.
loose.
3. Fan wobbles
1. Set screws in motor coupler are loose.
1. Tighten both set screws securely in the motor coupler.
excessively.
2. Set screw in hanger ball/downrod
2. Tighten the set screw in the hanger ball/downrod
assembly is loose.
assembly.
3. Screws securing fan blades to
3. Check to be sure screws which attach the fan blades
motor are loose.
to the motor are tight.
4. Hanger bracket and/or ceiling outlet
4. Tighten the hanger bracket screws to the outlet box,
box is not securely fastened.
and/or secure outlet box.
23
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF279
