10
How to Wire Your Ceiling Fan
(continued)
STANDARD ON-OFF WALL
SWITCH OR OPTIONAL SW406
WALL CONTROL
BLACK
BLACK
WHITE
RED
BLACK
WHITE
HANGER BALL
GREEN WIRE (GROUND)
FROM HANGER BALL AND
HANGER BRACKET
TWO-CONDUCTOR
CABLE (WITH
GROUND)
BLACK
(HOT)
WHITE
GROUND
TO
120-
VOLT
SUPPLY
WHITE
BLUE
WHITE
BLUE
Figure 15
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the ceiling cover and the
ceiling.
WARNING
!
3.
Push the wires and connectors up into the outlet
box while inserting the receiver fully into the hang-
er bracket. Position the antenna wire on top of the
receiver.
4.
Screw the two 1-1/4” threaded studs (supplied)
into the tapped holes in the hanger bracket (Figure
16).
5.
Lift the ceiling cover up to the threaded studs and
turn until the studs protrude through the holes in
the ceiling cover (Figure 16).
6.
Secure the ceiling cover in place by sliding lock-
washers (supplied) over the threaded studs and
installing the two knurled knobs (supplied). (Figure
16). Tighten the knurled knobs securely until the
ceiling cover fits snugly against the ceiling.
7.
Screw the two 50-watt mini-candelabra base halo-
gen bulbs (supplied) into the light kit plate sockets
(Figure 17). Do not touch the glass bulb; use the
porcelain base to screw in the bulb, or wear soft
gloves.
CAUTION: To avoid risks of burns or other injury,
assure power is off before attempting to install or
replace the halogen bulbs.
NOTICE: Do not touch halogen bulbs with bare
hands. Fingerprints may result in shorter bulb
life. Remove fingerprints with alcohol.
THREADED
STUD (2)
CEILING
COVER
KNURLED
KNOB (2)
LOCKWASHER
(2)
Figure 16
LIGHT KIT
PLATE
GLASS
50-WATT
HALOGEN
BULB (2)
FLAT AREA
Figure 17
8.
Place the lower glass into the light fitter, aligning
the three flat areas on the top flange of the lower
glass with the three pins on the inside of the fitter
(Figure 17). Then turn the lower glass clockwise
until it stops turning.
9.
Your ceiling fan is now installed and wired to be
controlled by your wall control.
U.L. Model No.: CF205
Summary of Contents for CF205BS01
Page 17: ...17 U L Model No CF205 Notes ...
