March 2014
Installation and Maintenance Manual
E-90090005 Rev. A
4
Section 3: Storage Instructions
Storage Instructions
Section 3: Storage Instructions
Proper storage is required when the operator will not be used immediately.
1.
Remove all dirt, dust, grease, and contaminants from any exposed, unpainted
surface (for example, Drive Rod OD, Yoke ID) by using a soft cloth dampened with
an appropriate oil based solvent. Avoid using abrasive material when cleaning rod
surfaces.
2.
Lightly grease any exposed, unpainted surfaces.
3.
Any plastic plugs used to plug the pressure ports during assembly should be
removed and replaced with steel plugs. All controls should also be plugged with
steel plugs.
NOTE:
Sealants such as pipe dope or Teflon tape should be applied to steel plug threads.
4.
Lightly lubricate all exposed threads and unpainted surfaces
(for example, mounting surfaces).
5.
Cover the PressureGuard™ to prevent accumulation of dirt and debris.
6.
Repeat the storage steps listed above to ensure the proper storage condition
(in case the PressureGuard™ will be moved and stored again).
Indoor environment is the ideal storage condition for BETTIS™ PressureGuard™.
For additional information on storage, please contact the manufacturer.
Summary of Contents for Bettis PressureGuard
