October 2015
Service Instructions
124842E Rev. C
27
Section 5: Module/Component Removal and Installation
Module/Component Removal and Installation
NOTE:
The guide block can be moved by inserting a long rod through either end of the housing
and by pushing on the guide block.
5�6�2
Lubricate two spherical washers (1-40) and one extension rod assembly (1-50).
5�6�3
Install one spherical washer (1-40) into the side of guide block (1-30).
NOTE:
The spherical side of washer (1-40) will be facing the outside of guide block (1-30).
5�6�4
Install second spherical washer (1-40) over threaded end of extension rod
assembly (1-50).
NOTE:
The spherical side of the washer will go on the extension rod assembly facing the head of
the extension rod assembly.
5�6�5
Install extension rod assembly (1-50) into right of guide block (1-30) and up
against the first spherical washer (1-40).
5�6�6
Install extension retainer nut assembly (1-60) over extension rod assembly (1-50)
and screw into guide block (1-30).
5�6�7
Tighten extension retainer nut assembly (1-60) until extension rod assembly
(1-50) cannot move. Back off the extension retainer nut assembly (1-60) just
enough to allow for the extension rod assembly (1-50) to move freely.
