1.
Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing assembly
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/4.5” downrod assembly
f. One hanger bracket
g. One coupling cover
h. Five fan blades
i. One loose parts bag containing:
1. Sixteen M5 x 6mm washer head
blade screws
2. One M4 x 12mm flat head screw
3. One M6 x 14mm pan head screw with
lockwasher
4. One die-cast pendant
5. One pendant coupler
6. Three wire connectors
7. Two threaded studs
8. Two knurled knobs
9. Two lockwashers
10. One clevis pin
11. One hairpin clip
12. One balance kit
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
One stepladder
One wire stripper
Three wire connectors (supplied)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
3
Installed Wire Length
Wire Size A.W.G.
Up to 50 ft.
14
50-100 ft.
12
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 8). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2.
Remove the fan assembly from the protective
plastic bag. Place the fan assembly into the upper
foam pad with the bottom of the motor facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.
LOOSE PARTS
BAG
CEILING
COVER
BLADE
FLANGES
COUPLING
COVER
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
SWITCH HOUSING
ASSEMBLY
FAN MOTOR
ASSEMBLY
BLADES
WARNING
!
WARNING
!
WARNING
!
U.L. Model No.: CF452
