Emerson AMHURST CF880BS00, Owner'S Manual

Page: 5 / 20

5. Make sure the grommet is properly installed in the
coupler cover, then slide the coupler cover on the
downrod until it rests on the motor housing. Place the
ceiling cover over the downrod. Be sure that the
ceiling cover and the coupler cover are both oriented
correctly (Figure 3).
6.
Reinstall the hanger ball (Figure 3) on the downrod
as follows. Route the three 80” motor leads through
the hanger ball. Position the pin through the two
holes in the downrod and align the hanger ball so the
pin is captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball.
A loose setscrew could create fan wobble.
7. The fan comes with blue, black and white leads that
are 80-inches long. Before installing the fan, measure
up approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and
strip back insulation 1/2-inch from end of leads.
8. Carefully rotate the partial assembled ceiling fan
and place gently into the styrofoam to compete the
final installation of the fan.
9.
Attach the blade flange to the fan blade using the
#10-32 x 1/4” washer head screw. Use three screws
with lockwashers per blade assembly (Figure 4).
10. Repeat this procedure for the remaining four blades
and flanges.
NOTE: Take care not to scratch fan housing when
installing blades.
11.
Install one blade assembly on the top of the motor
housing using two 1/4-20 x 1/2” pan head screws
with lockwashers (supplied) (Figure 5).
12. Repeat this procedure for the remaining four blades
assemblies.
Ceiling Fan Assembly
(continued)
5
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF880
#10-32 x 1/4"
WASHER HEAD
SCREW (3 per
blade/flange)
BLADE
FLANGE
Figure 4
1/4-20 x 1/2" PAN HEAD
SCREW WITH
LOCKWASHER (2 per
blade/flange assembly)
BLADE/FLANGE
ASSEMBLY
MOTOR
HOUSING
Figure 5
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
WARNING
!
COUPLER
COVER
CEILING
COVER
PIN
HANGER
BALL
GROMMET
DOWNROD
Figure 3
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!