ASSEMBLY INSTRUCTIONS
- 3 -
1. Please check to ensure that the package you have received contains the following:
1 each Base containing:
1 each Hardware Package containing:
4 each casters
1 each 5/16 - 18 x 1" hex head screws
4 each 5/16"
lock washers
1 each 5/16" split lock washer
1 each Pole Assembly
1 each 5/16" flat washer
1 each Head Assembly
4 each #8 - 32 x 1/2" button head screws
2 each Bulbs
4 each #8 lock washers
1 each 3/32" Allen wrench
2. Remove the Base from it's box and unwrap it from it's padding. Screw the four casters into the base using the 5/16" lock
washers. Unwrap the Pole Assembly and position in the Base Assembly as shown in Fig. 1. Secure it in place using a 5/16 - 18
screw, a 5/16" lock washer and a 5/16" flat washer.
3. Remove the Head Assembly from the package and unwrap it. Place it, bezel side down, on a work surface with the bar facing
you. While holding the lamps, rotate the Tee Bar up approximately 45 degrees. Lean the Base/Pole Assembly forward so that
the mount plate at the top of the pole meets the center of the Tee Bar. Connect the cable from the pole to the cable from the bar
and push the cable and any excess wiring into the bar. Bring the mount plate and Tee Bar together and secure using the four
8-32 x 1/2" button head screws and four #8 lock washers.
4. Stand the Light Assembly upright. Install the two bulbs following the "Bulb Replacement" instructions on page 6.
OPERATING INSTRUCTIONS
Initial Setup
Plug the power cord into a suitable grounded electrical outlet (110-120 volts, 60 Hz, unless otherwise specified).
Light Position
Position the light over the patient. Grasp the loop on the measuring tape, located on the right lamp assembly, and extend the tape to
the double red lines, which are 28" (71 cm), from the end. With these lines aligned with the bottom of the lamps and the loop tip
just touching the patient, you will attain the spacing of 28" (71 cm) between the lamps and the patient that clinical experience has
shown is suitable for maintaining the patient's temperature during limited periods.
Height Adjustment
Hold onto the upper pole while pulling the height adjustment knob out. Move the upper pole to the desired height and release the
knob. The spring-loaded knob should engage one of the holes in the upper pole, locking it in position. Once the proper distance has
been achieved, attach the safety pin in the next higher hole.
Lamp Adjustment
Grasping the bezel handle and rotating the lamp assembly easily changes each lamp. Stops are provided to limit the rotation.
