2 0
Storing Numbers In The Handset Memory
You can store up to 13 of your most frequently called numbers in the handset
speed-dialing memory. The keypad buttons
M1
,
M2
, and
M3
are one-touch
memories. Simply pressing any one of those buttons will immediately dial the stored
number. The keypad buttons “
0
” through “
9
” are two-touch memories. To dial a
stored number you must first press the
MEMORY
button, and then press the desired
number button to dial the stored number.
To store numbers:
1.) Lift the handset from the cradle.
Note
: After a few seconds, you will hear the “
Off the hook/hang up
”
warning signal from the telephone company. You may continue through
the steps as below. However, if you are going to store many numbers,
suggest to press “
Hook
” button on the cradle periodically.
2.) Press the
STORE
button on the keypad.
3.) Dial the area code and number you wish to store. Don’t forget to dial a “
1
”
before the area code if necessary.
Note
: The maximum number of digits that can be entered in any memory
location is
16
.
4.) Press the
STORE
button again, and then press the desired memory location
button, either
M1
,
M2
,
M3
, or Number keys “
0
” through “
9
”.
5.) Repeat this procedure until you have stored up to 13 frequently dialed numbers.
To change a number stored in any memory just perform Steps 1 through 3 above
and store the new number in the desired memory location. The old number will be
deleted when the new number is stored.
CKT9087_090606.p65
6/9/2006, 10:56
20
