emerio HO-124290, Instruction Manual

Page: 6 / 46

- 5 -
HO-124290 EN
DESCRIPTION
1. Radiator fins
2. Handle
3. On/off power switch and indicator light
4. Thermostat knob
5. Rear stand
ASSEMBLY
1. Turn the heater upside down on a scratch-free and flat stable surface. (Fig. A)
2. Fit the rear stand into the last fin with screw hole facing outward and press it down. Secure the rear stand
with the two screws supplied with the appliance. (Fig. B).
3. Turn the heater into its upright position before operation. (Fig. C)
Warning: Do not use the heater without assembling the rear stand as this might damage your flooring.
USING THE APPLIANCE

Set the thermostat knob to the minimal position and insert the plug to the power supply.

Press the on/off power switch to position “I”.

Turn the thermostat knob in a clockwise direction to the max position. The indicator light will illuminate.

Once the room temperature has reached the desired value, turn the thermostat knob slowly in
anti-clockwise direction until you hear a "click" sound; this is the setting temperature.

The appliance will automatically maintain the setting temperature. It will switch on when the room
temperature is below the setting, and switch off if it is above the setting.
Overheat protection
This heater is protected with overheat protection that switches off the appliance automatically in case of
severe overheating. In this case, unplug the appliance, wait about 30 minutes for it to cool and remove any
possible cause of overheating, eg. something covering the heater. Check for damage to the appliance, the cord
and the plug. If there is no damage, plug the unit back in and switch it on as described above. If the heater still
does not turn on, please contact Customer Service for assistance.