18
“Set-Point pH” (PWM)
This mode is valid for any “Digital” output available. Pulse-width modulation (PWM) of a signal or power source invol-
ves the modulation of its duty cycle, to either convey information over a communications channel or control the amount
of power sent to a load.
This mode works over a settable (0 to 100 seconds) time to switch on or off selected output.
During this time if reading value will move towards a set value (on or off) the PWM will operate the output on timered
basis. Reaching the set value the PWM will permanently leave on or off the output.
Parameters to set for this mode are:
Unit Value + %:
(time activity towards set value. 0% means 0 seconds. 100% means 100 seconds.
)
pH range:
two pH values within PWM operates.
For example: set first pH value at 8.00 = 100% and second pH value at 4.0 = 0%.
For reading values ≥ to 8.00 the output will be permanently ON.
For reading values ≤ 4.0 the output will be permanently OFF.
For reading value of 7.00 the output will be OFF for 25 seconds, ON for 75 seconds.
For reading value of 6.00 the output will be OFF for 50 seconds, ON for 50 seconds.
4.00
5.00 6.00 7.00
8.00
ON
OFF
0%
50% 75%
100%
Summary of Contents for Centurio POOL
Page 44: ...44 Appendix Logical Working Scheme pool...
Page 47: ...47...
