4
SVR-D1U-R610 Installation and Replacement Guide
Installing the server in a rack or cabinet
Installing the server in a rack or cabinet
This section describes how to install the SVR-D1U-R610
server. It is
divided into the following sections:
◆
“Mounting kit parts” on page 4
◆
“Removing inner rails from the universal rail kits” on page 5
◆
“Attaching the inner rails” on page 5
◆
“Installing the universal rails in the cabinet” on page 6
◆
“Installing the server in the cabinet” on page 7
◆
“Installing bezels” on page 10
Mounting kit parts
The server mounting kit includes rails, hardware, and bezel as listed
in the following table.
You will need a # 2 Phillips-head screwdriver to complete the
installation of the rails and server.
Component
Use
2 adjustable universal slide rails
Attach front to back on either side
between NEMA channels
Two Phillips M5 18 mm screws
Stabilize the rail mounting
1 U bezel (front rack panel)
One per server — application specific
(includes inner rails for
connection to server)
