EMC Celerra NX4, Installation Manual

Page: 8 / 34

8
For more information, refer to Celerra Tools on http://Powerlink.EMC.com
Remove components from shipping container
Caution: Two people are required to remove the components. Only remove the
screws holding the components in place at this time. Do not remove the screws holding
the mini-rack rails in place; this may cause damage to the components. Only remove
one component at a time.
TLA Serial Number
Model Number
DART Version
Flare Version
Unit Tested
Pre-Configured
MAC Address
SPA IP: 192.168.1.200
SPB IP: 192.168.2.201
Control Station (CS)
Standby power supply (SPS)
Disk processor
enclosure (DPE)
Blade enclosure
Do not remove the mini-rack
from shipping container.
CNS-001429
2
3
4
1
Remove this label and
paste it on the back of
the front cover of this
installation guide.
Disk processor
enclosure
Standb
y po
we
r supply
Control Station
Blade enclosure
2
3
4
1
TLA Ser
ial Number
Model Number
DA
R
T V
ers
io n
Flare V
ersion Unit T
ested
Pre-Configured
MA
C Address
SP
A IP:
192.168.1.200
SPB IP:
192.168.2.201
2. Carefully set aside each component as
it is removed (
1-4 ) from the disposable mini-rack
shipping container.
3. The ganged rails remain in the mini-rack
shipping container at this time.
1. Using a Phillips-head screwdriver, remove only six screws per side.
Keep the screws to install the components in your site rack.
!