3
For more information, refer to Celerra Tools on http://Powerlink.EMC.com
Before you begin
!
Welcome
The system you are about to install comes factory pre-loaded with Celerra
®
Network Server software
(DART) and CLARiiON
®
storage array software (FLARE
®
).
Software upgrade
If you bought a software maintenance contract, you are entitled to a software upgrade that is
performed only after the installation, Celerra Startup Assistant (CSA), and registration have
successfully completed.
Site preparation
Complete the site preparation by verifying the following activities before instal lation:
Network connections
•
Power requirements
•
Rack space requirements
•
Default IP addresses
The system components communicate with each other using a private Internet Protocol (IP) network.
By default, this network uses the IP addresses listed in the following table.
If your existing IP network uses addresses on these subnets, you are required to change the private
network addresses of your Celerra Network Server to different subnets before the installation.
Primary internal network
128.221.252.100
Backup internal network
128.221.253.100
Netmask
255.255.255.0
IP address of storage processor A
128.221.252.200
IP address of storage processor B
128.221.253.201
Gateway IP address of storage processor A
128.221.252.104
Gateway IP address of storage processor B
128.221.253.104
Internal
system
addresses
Factory
values
Summary of Contents for Celerra NS20FC
Page 24: ...24...
