EMC-PARTNER 103538, User Manual, Page: 11 / 28

E-CN16-E-Manual 11/28
3 Connecting CN16 toTRA3000
3.1 General
Use the three cables (red, yellow and yellow/green) supplied to connect the CN16 to the TRA3000 C
For common mode tests connect the CN16’s ‘AC-L’ and ‘AC-N’ to the TRA3000 C ‘EUT Power L and ‘EUT
Power-N’ (as shown on the following picture for example).
The metallic box of the CN16 must be connected to the PE of the TRA3000
Caution
To avoid any damage of the EUT during CM test set-up the EUT power cord on the rear side of the
TRA3000 shall be removed. When the CM test is selected the power line is disconnected and the PWR1
and PWR2 can not switched “ON”. As soon as an other test e.g. Surge is selected the PWR1 and PWR2
can be activated and the power voltage is on L at the front of the TRA3000.