EMBRON Hatteland HT20 70 Series, User Manual

Page: 31 / 154

31
IND100210-66
General Installation Recommendations
Installation
Replacing Internal CMOS/BIOS Battery
Note: Areas of interest are marked in this section with arrows in RED color. Please disconnect ALL cables from the
computer unit before proceeding! Procedure applies for all HT20x70 models.
Please review “Product Storage” recommendations document, ref:
https://www.hattelandtechnology.com/hubfs/pdf/misc/ind100350-5_long_term_storage_recommendations.pdf
NOTE: All BIOS settings, Date and Time will be lost if battery is removed from motherboard. If Factory Default BIOS
settings was changed after unit was received from factory, please write down changes (if known) before doing this
procedure. Operating System installed will not be affected by a battery replacement. After battery was replaced and
unit powered, check BIOS settings and choose to load Factory Default Settings, change time and date. BIOS
Settings and its adjustment are outside the scope of this chapter in User Manual. Consult your experienced technician
or contact our service / support channels worldwide for further assistance if unit does not operate as intended.
1: Unscrew 8 screws from top of cabinet.
Use a Pozidriv #2 screwdriver.
2: Lift the cover up with both hands.