Embraco Sliding unit Series Installation Instructions Manual Download Page 7

Page: 7 / 48

Installation Instructions

Read the following instructions

carefully before installing the unit.

Thank  you  for choosing a EMBRACO Sliding  unit.  It is housed air cooled  condensing unit.  This unit  has  been
specifically   designed for  refrigeration and  with  service   friendly  installation in  mind  to  save  your  time   on
site:  easy  access to  components.

This technical instruction leaflet includes detailed information concerning installation, start up, servicing
and maintenance.

1. WARNING

1.1 Transport and handling.

Do not transport or handle the unit up-side down because the unit contains

compressor with oil.

1.2 Installation.

• This condensing unit and all related equipment must be installed by qualified staff.

• The installation should be carried out in accordance with the relevant refrigeration and electrical

standards which apply in that country. Refrigeration best practice must be followed.

• EMBRACO shall not under any circumstance be liable if the installation and maintenance are not carried

out in accordance with the instructions given in this manual.

2. TECHNICAL DATA

2.1 Identification label for the HOUSED CONDENSING UNIT range

(See picture

)

Always check if the

label correspond to the required model to be installed.

2.2 Safety devices.

All units are supplied with an adjustable LP pressure switch and fixed value HP

pressure switch, with a 6A maximum current rating.

3. INSTALLATION

3.1 Unpacking.

Before unpacking the unit, check that the packaging has not been damaged in any way

and that the exterior is in good condition.

3.2 Handling.

The packaged condensing unit can be lifted by forklift or pallet truck The unit should

therefore be kept in its packaging until it has been moved to the installation site. Once the packaging has
been removed, “sliding units” can be moved.

Warning:

do not lift or move the product by its housing when opening the housing.

3.3 Location.

Housed condensing units should not block or obstruct thoroughfares, doors, shutters or the

movement of personnel. The surface supporting the  condensing unit  must be  level  and  capable of bearing the
combined weight   of  the  unit  + support. Ensure  there is  sufficient  distance between the  condensing unit  and
objects in  the  surrounding area   to  ensure good  air  circulation.

MIN: 200 mm free area.

(See picture

)

Housed  condensing  units   must  be  installed  in  well  ventilated  but   not   windy  locations.  Ensure   there  is
good  air  circulation to  the  condenser. There  must be  no  obstacles in front  or  to  the  side  of  the  unit  which
would  cause air  recirculation to  the  condenser resulting in an  abnormally high  condensation temperature.
The  housed condensing unit  must be  mounted in a  level  position according to  best  refrigeration practice.
Ensure   that the  condensing unit  is  kept  away  from  heat  sources, damp areas,  corrosive atmospheres  or
any  sites where  there is a  risk of explosion. Do not  exceed the  recommended service  pressure.

3.4 Noise levels.

Precautions must be taken during installation to avoid generating additional noise

and vibration:

• units must be securely mounted on a stable, rigid base,

• connecting pipe work must be sufficiently flexible to ensure vibration is not transmitted to the rest of

the installation.